What we are looking for:
Side of the street, and a distance and direction from the cross
street.
For example:
East side of 20th St approximately 500’ North of I St
What we are looking for:
Side of the street, and a distance and direction from the cross
street.
For example:
East side of 20th St approximately 500’ North of I St
What we are looking for:
Needs to include a distance and direction from the cross street and then
a
Distance and direction away from the street.
For example:
At a point approximately 500’ North of I St & 300’ East of 20th St
What we are looking for:
Popular for remote digsites or when there are winding roads that are
difficult to measure along. You can simply give a single distance and direction from the intersection to
your
digsite as the crow flies.
For example
At a point approximately 1.3 MI North East as the crow flies of the intersection of
7th
Standard Rd & Porterville Hwy
What we are looking for:
Give the side of the street and then provide the distance and direction
your work area extends. If working away from the road give the distance and direction.
For example:
Both sides of E.Mckinley Ave from entire intersection of N.Orchard St extend
approximately
2200’ E & include 15’ into property for entire distance.
Or for example:
S Side of E.Mckinley Ave from 500’ E of N.Orchard St extend 1000’ E
What we are looking for:
A distance an direction from the nearest intersection to the start point
and then provide the distance and direction the work area extends. Basically you want to give the dimensions
of the digsite. This can be achieved a few different ways but we outline two of the most simple and direct
methods below.
For example:
From the intersection of CA-4 & Balfour Rd go 1000’ W & extend 1500' S working the
entire
area within
Or for example:
From the intersection of CA-4 & Balfour Rd go 1000’ W turn & go 1500’ S turn & go 1000’ E
Turn and go 1000’ N working the entire area within
What we are looking for:
Please write the address and in your description provide where on the
property you are working. If the address does not get automatically mapped with our system then please
select
the “Line” tool (located under the map) and be sure to map out the address where you know it to be located.
If working multiple addresses then list the addresses you are working or the range of addresses and give a
description of where on the properties you are working and then using the line tool make sure to encapsulate
the entire digsite area.
For example:
Work entire property at addresses 6341-6512 20th St
Or for example:
From the intersection of CA-4 & Balfour Rd go 1000’ W turn & go 1500’ S turn & go 1000’ E
Turn and go 1000’ N working the entire area within